# An introduction to the experiment heat of fusion of a substance

So that is what?

Click on the pink button to view a QuickTime movie showing an animation of the refrigeration cycle. At least over that little period right here. As the pressure of the gas increases, so does its temperature as predicted by the ideal-gas law.

Example If you had a The liquid Freon in the external coil passes through an expansion valve into a coil inside the insulated compartment of the refrigerator. This control mechanism allows the refrigerator to conserve electricity by only running as much as is necessary to keep the refrigerator at the desired temperature.

The calorie or gram-calorie is the amount of energy required to raise the temperature of one gram of water from But what about these parts right here?

It's not an irrevocable mistake, otherwise I would rerecord the video.

I might off a little bit on that number, but that digit is not that significant. There are many forms of kinetic energy, for example the vibrational, rotational, and translational.

For example, the heat of fusion of water is 6. The insulation of the Styrofoam cup during experiment should be done to minimize the heat loss to the surrounding. I point out that the five measurements indicated on the paper should be able to be found when following their written procedures.

Where the increased heat is not used to increase the temperature of the water, it's used to put potential energy into the system. That's to go from zero degree water to degree water. When all of the Freon changes to gas, the cycle can start over. Heat produced by one gram of peanut was higher than heat produced by one gram of the candle by nearly by a half So, times 10 degrees Kelvin.In this experiment, the specific heat of a solid was determined by the method of mixtures; the latent heat of fusion and heat of vaporization of water were determined.

Specific heat Specific heat is the amount or quantity of heat per unit of mass of a substance required to raise its temperature to 1 degree Celsius. Latent Heat of Fusion Abstract Latent Heat of Fusion (Lf) is the heat energy absorbed of the substance as it changes its state from the solid state to the liquid state without the change in temperature.

This is expressed in joules (J) per unit mass (kg) of the substance. In this experiment, our goal. The heat capacity, which is defined as the amount of heat required to raise the temperature of a given quantity of a substance by one degree Celsius,(unit is J/ 0 C) of the entire system, denoted by,is represented as the sum of the heat capacities for the individual components involved in.

capacities in the liquid and solid phases and also the latent heat of fusion.

Explanations of the heat capacity and latent heat of a material can be found in Appendix C. physical property of a substance is the amount of energy it will absorb per unit of mass.

This property can be measured quite accurately and is called specific heat (C p). This is a simple experiment to measure the "specific heat" (also called "specific heat capacity") of any fluid. In addition to the principle of specific heat, the experiment also demonstrates some basic electrical principles such as Ohm's law.

An introduction to the experiment heat of fusion of a substance
Rated 3/5 based on 86 review